Is there somewhere 3d model available roseapple pi?
I've had 3d printed version 1. It's almost ok, but microusb port can't be connected properly, because it is too inside(recessed) in the case & the microusb cable(the black connector) doesn't fit inside the hole of the case
Hello. I fix this on this week
Hello cyryllo,I wanted to print the case1. Is the issue mentioned by csgabe fixed now?
Here: http://www.tantron.io/web/product/roseapple-pi-case/ the "official" case can be found. There are a lot more openings in it. I think this should be better for ventilation.May it be possible to add them to the current case1?
Hello.I'm sorry that it was only written down but I'm still busy. I will try in the near future to update the case and add a completely new;)